Replies

• RugerFan Senior Member Posts: 2,314 Senior Member

  July 26 #2

  I ain't got a clue but welcome to the forum.

  0 · Share on TwitterShare on Facebook
• KosmoCramer Posts: 20 New Member

  July 26 #3

  RugerFan said:

  I ain't got a clue but welcome to the forum.

  No problem, Thank you!

  0 · Share on TwitterShare on Facebook
• earlyagain Posts: 6,749 Senior Member

  July 26 #4

  This is just a guess. I doubt the screw is sensitive to specific torque value. That would be counter to the purpose of a takedown rifle of that type. I bet snug will be adequate.

  1 · Share on TwitterShare on Facebook
• Diver43 Senior Member Posts: 10,936 Senior Member

  July 26 #5

  Welcome to the forum
  I called Marlin regarding torque for a similar rifle, they recommended 30 inch pounds.  Give them a call to check yours

  Logistics cannot win a war, but its absence or inadequacy can cause defeat. FM100-5

  1 · Share on TwitterShare on Facebook
• Gene L Senior Member Posts: 11,744 Senior Member

  July 26 #6

  Snug tight.  Average gun owners back then, and even now, don't have torque wrenches.

  Concealed carry is for protection, open carry is for attention.
  

  1 · Share on TwitterShare on Facebook
• Bigslug Senior Member Posts: 8,267 Senior Member

  July 26 #7

  Gene L said:

  Snug tight.  Average gun owners back then, and even now, don't have torque wrenches.

  Hell, on that sort of gun, probably not even the factory.  Go a quarter to half turn past the point the metal stops wiggling in the wood and call it a day.

  WWJMBD?
  
  "Nothing is safe from stupid." - Zee

  1 · Share on TwitterShare on Facebook
• NN Senior Member Posts: 24,720 Senior Member

  July 26 #8

  Welcome aboard

  Shut up-----KAREN; OK Cynthia

  1 · Share on TwitterShare on Facebook